Skip to content
A hand holding a coil of red and black wire from the Legacy Automation Conversion Kit

Poolside Tech

Legacy Automation Conversion Kit

Poolside part no. ATT-LACK

Moves an existing IntelliCenter, OmniLogic, AquaLink or similar panel’s relay connections over to The Attendant, without tearing the old panel out.

$445 CAD

Equipment only, before tax. Have it shipped, or book a site visit and we install it: the install is quoted in writing after the visit.

About it

In a typical retrofit the old panel stays on the wall as the power centre, and Poolside’s conversion kit moves the relay connections over to The Attendant. That means no tear-out and no rewiring every circuit.

Whether it fits your panel depends on the panel, so we confirm it on the site visit before anything is ordered.

Works with

  • Pentair IntelliCenter
  • Hayward OmniLogic
  • Jandy AquaLink

Specs

  • 8 15 ft cables, cut to length
  • Keeps the existing panel as the power centre
  • Moves relay control to The Attendant
  • Confirmed against your panel on the site visit

The Attendant® and Poolside Tech are trademarks of Poolside Tech. Product details are from Poolside Tech and may change.

Also in the shop

Automation add-ons

The Chemistry Module kit: sensor cables, pH calibration buffer packets and the chemistry circuit board

Poolside Tech

Chemistry Module

An add-on for The Attendant or Attendant Mini that monitors pH and ORP around the clock and doses automatically.

From $1,155 CAD

A hand holding the pH and ORP probes beside two Poolside Tech boxes

Poolside Tech

Chemistry Probe Kit

A pH probe and an ORP probe for The Attendant + Chemistry and The Attendant Mini + Chemistry.

$865 CAD

The clear Chemistry Sensing Flow Cell held in a hand, shown with pH and ORP probes fitted

Poolside Tech

Chemistry Sensing Flow Cell

Holds the chemistry probes in the plumbing for continuous, accurate readings. Probes are not included.

$585 CAD

Want to see if it fits your pad?

Serving Kelowna, West Kelowna, Lake Country and Peachland. Send photos of the equipment pad and you will get a straight answer back, usually the same day.