Hayward automation · Kelowna & the Okanagan
Keep your Hayward equipment. Upgrade the controller.
If your pool runs on a Hayward OmniLogic, OmniPL, ProLogic or AquaLogic, the pump, heater and salt cell can stay. The Attendant by Poolside Tech takes over the control side and runs your Hayward equipment, plus anything from another brand, from one app. We install it in Kelowna and across the Central Okanagan.


Hayward systems we upgrade
Not sure which one you have? Send a photo of the panel and the equipment pad. That is usually enough to tell.
- Hayward OmniLogic
- Hayward OmniHub
- Hayward OmniPL
- Hayward ProLogic
- Hayward AquaLogic
- Hayward AquaRite
Why Hayward owners switch
Same pad, a much smarter system.
Most brand automation is built to sell more of that brand’s equipment. The Attendant is built to run the equipment you already own.
Your Hayward equipment keeps working
Hayward variable-speed pumps, heaters, valve actuators and lights all run on The Attendant, and Poolside supports every make of salt chlorinator, so an AquaRite cell stays in service.
The old panel can usually stay
In a typical retrofit of an OmniLogic or similar panel, it stays on the wall as the power centre and Poolside’s conversion kit moves the relay connections over. We confirm it against your panel on the site visit.
Mix brands freely
A Hayward pump, a Raypak heater and a Pentair salt cell can all live on the same system. Replacements no longer have to match the controller.
Problems show up early
Alerts for a dirty filter, low water, a leak or equipment that is not behaving, to your phone and to us if you want us watching. If a valve actuator fails, it shuts the pump down to protect it.
The Attendant by Poolside Tech
What you get after the switch.
Two sizes: The Attendant, with a touchscreen at the pad, and The Attendant Mini for simpler pools. We recommend one after seeing your equipment.
- Works with what you already have
- Heating that plans ahead
- See what the pool costs to run
- Hear about problems before they get expensive
- Chemistry on autopilot (optional)
- Lights, music and water features
- Keeps the water level right
- Guest and rental mode
- Part of your smart home
- Filtration that adapts
- Freeze protection and cover detection
- A record of who changed what
How a Hayward upgrade works
Look at the pad
We come out, go through your equipment and how you use the pool, and confirm every piece is supported.
A written plan and quote
Which model, whether chemistry makes sense, and exactly what gets connected. Nothing changes on install day.
Install and setup
We mount the controller, connect the equipment, sensors and valves, and set up schedules and heating around your routine. A licensed electrician makes the 120/240V connections under permit, as BC requires.
Handover and support
We walk you through the app and stay on as your dealer for remote diagnostics, updates and anything that acts up.
Installs cover Kelowna, West Kelowna, Lake Country and Peachland. Further along the Okanagan? Ask anyway; a bigger job is often worth the drive.
Hayward upgrade questions
Will my Hayward salt system still work?
Yes. Poolside supports all makes of salt chlorination, Hayward’s included. We check the exact cell and controller on your pad during the site visit.
Do I have to remove my OmniLogic or ProLogic panel?
Usually not. In most retrofits the existing panel stays as the power centre and The Attendant takes over the control side. It depends on the panel, so we confirm it on site and put it in the written quote.
I have an old ProLogic or AquaLogic with no app. Is this the upgrade?
It is one of the most common reasons to switch. You get full control from your phone, heating that plans around the forecast and energy cost by device, without replacing the pump, heater or salt cell that already work.
Can you look at my Hayward system before I decide?
Yes. The site visit is where we go through what is on the pad, how it is wired and what you actually use. If the honest answer is that your current system is fine, we will say so.
A different brand on your pad?
Send us a photo of your Hayward pad.
Brands and models if you know them, or just photos of the panel and equipment. We will come back with what an upgrade would take. Quotes are free.
Pentair, IntelliCenter, EasyTouch, IntelliTouch, IntelliConnect, ScreenLogic, IntelliFlo, Hayward, OmniLogic, OmniHub, OmniPL, ProLogic, AquaLogic, AquaRite, Jandy, AquaLink and iAquaLink are trademarks of their respective owners. Simply Swim is an authorized Poolside Tech dealer and is not affiliated with Pentair, Hayward or Jandy. The Attendant® and Poolside Tech are trademarks of Poolside Tech.