Skip to content
Equipment Repair

The part most pool companies hand to somebody else.

Pumps, filters, heaters, salt systems, plumbing and valves — diagnosed and repaired in-house, with real mechanical and fabrication know-how behind it.

Simply Swim technician servicing a pool pump and sand filter at an equipment pad

No referral, no second contractor, no three-week wait for someone else to call you back.

What's included

What we diagnose and repair.

Pumps and motors

Seals, bearings, impellers and lids. Loss of prime, air leaks on the suction side, and noise that means something is about to fail.

Filters

Sand changes, cartridge replacement, multiport valve rebuilds, internal laterals, and finding the reason sand keeps coming back to the pool.

Heaters

Ignition faults, error codes, pressure switches, and heat exchangers ruined by water that was never balanced properly.

Salt systems

Cell cleaning and replacement, controllers that read wrong, and output that has quietly dropped off over two seasons.

Plumbing and valves

Leaks, cracked unions, seized or wrongly-set valves, and repiping at the pad where it has been added to one repair at a time.

Straight diagnosis

You get told what is wrong, what it costs, and whether it is worth fixing or replacing. Sometimes the honest answer is to leave it alone.

How it works

  1. Describe the symptom

    What it is doing, what changed, and any error code on the display. A photo of the equipment pad tells us a great deal before we arrive.

  2. Diagnose on site

    The system gets run and tested rather than guessed at. Replacing parts until something works is not diagnosis.

  3. Quote before work

    You get the cost and the options before anything is taken apart. No work happens without your say-so.

  4. Repair and verify

    Fixed, run, and checked under load — then a report of what was replaced and why.

Common questions

My pump is loud. Is that serious?

Usually it is bearings, and it is a warning rather than an emergency — but a bearing that fails completely can take the motor with it. It is much cheaper addressed early.

Do you work on equipment you did not install?

Yes. Most of what we see is existing equipment of every age and brand.

Is it worth repairing an old heater?

Sometimes, sometimes not. If the heat exchanger is scaled through, repair costs approach replacement and you are buying a short reprieve. We will tell you which situation you are in.

Do I need to be on weekly service to get a repair?

No. Repairs and diagnostics are available on their own.

Can you add automation while the pad is being worked on?

Yes, and it is a good time to. Simply Swim is an authorized Poolside Tech dealer, and The Attendant runs the pumps, heaters, salt systems and lights you already have, whatever the brand. It also flags a dirty filter or a pump that is not behaving before it turns into a repair.

Also available

Other things we look after.

Pool water sample being tested against a chemical comparator on the pool deck

A full assessment of the pool, its equipment and its water, delivered as a written report with photographs. Built for buyers, for pre-season checks, and for pools that keep going wrong without an obvious reason.

Learn more

Pool technician skimming leaves from the surface of a clean backyard pool

Regular service through the season: the water balanced to the numbers, the pool cleaned properly, and the equipment checked on every visit. You get a report after every visit.

Learn more

Green mesh safety cover strapped tight over a closed pool, with autumn vineyards and Okanagan Lake behind

Seasonal opening and winterization done thoroughly, because almost every expensive pool failure in the Okanagan traces back to a rushed close in October.

Learn more

Something not working right?

Serving Kelowna, West Kelowna, Lake Country and Peachland. Send a few details about the pool and you will get a straight quote back, usually the same day.